Epson T3 Series User Manual

1. Safety
24 Safety and Installation (T, VT / EPSON RC+ 7.0) Rev.15
1.6 Labels
Labels are attached around the locations of the Manipulator where specific dangers
exist.
Be sure to comply with descriptions and warnings on the labels to operate and
maintain the Robot System safely.
Do not tear, damage, or remove the labels. Use meticulous care when handling
those parts or units to which the following labels are attached as well as the nearby
areas:
T series Manipulator
Location
Label
Note
A
Before loosening the base mounting
screws, hold the arm and secure it
tightly with a band to prevent hands or
fingers from being caught in the
Manipulator.
For installation and transportation of
robots
, follow the directions in this
manual.
B
Do not enter the operation area while
the Manipulator is moving. The robot
arm may collide against the operator.
This is extremely hazardous and may
result in serious safety problems.
C
Hazardous voltage exists while the
Manipulator is ON. To avoid electric
shock, do not touch any internal
electric parts.
D
You can catch your hand or fingers
between the shaft and cover when
bringing your hand close to moving
parts.

Epson T3 Series Specifications

General

Brand	Epson
Model	T3 Series
Category	Robotics
Language	English