Getting started
Horizontal operating position
If you wish to operate the device in the horizontal operating position, use
the two feet supplied for horizonta l operation.
Only mount the feet on the device side shown in the diagrams.
Proceed as follows to prepare the device for the horizontal operating position:
HorizontaloperatingpositionOperatingposition, horizontalBasefeet
► Disconnect the cables if required.
► Laythedeviceonitsright
side as shown, on a stable, flat and clean surface.
1
1
2
2
3
3
3
3
► Hook the feet into each of the openings provided for this in the casing (1).
There are lock symbols on the foot, indicating the direction in which the
foot must be pushed during installation or removal:
• Secure and lock the foot = push to the left (closed lock)
• Unlock and release the foot = push to the right (open lock)
► Repeat for each foot: Keep the " Push" button pressed down (see magnifier) and push
the foot in the direction of the arrow (2) until it is heard to engage.
Fujitsu 19
To Next Page
Loading...
Need help?
General
Weight and Dimensions
