6. DATA TRANSFER
6-1
6. DATA TRANSFER
This chapter provides information for saving and replaying data to and from memory cards,
uploading and downloading data, loading waypoint data from Yeoman, and outputting data
through the network.
6.1 Memory Card Operations
The memory cards store these data: marks, lines, waypoints, routes, track, position, water
temperature and setting data (plotter only). The following memory cards may be used:
Kingstone: SD-M64B1 (64 MB), SD-M128B1 (128 MB)
Viking: 32SD-M32B1 (32 MB), 64SD-M64B1 (64 MB)
EP Memory: 32 MB, 64 MB
SANDISK: 64SDSDB-64-J60 (64 MB), 128SDSDB-128-J60 (128 MB)
Panasonic: 64 RP-SD064BL1A (64 MB), 128RP-SD128BL1A (128 MB)
Toshiba: 64 SD-NAD064MT (64 MB), 128 SD-NA128MT (128 MB)
6.1.1 Deleting all data (other than chart data) from memory cards
Follow the procedure below to delete all data from a memory card.
1. Insert a blank memory card into the card slot.
2. Press the MENU key followed by the SYSTEM CONFIGURATION, DATA TRANSFER,
UPLOAD/DOWNLOAD DATA and SAVE DATA TO MEMORY CARD soft keys to show
the SAVE DATA menu.
SAVE
DATA
EDIT
SAVE
DELETE
RETURN
▲
TRACKS OFF
MARKS & LINES OFF
WAYPOINTS & ROUTES OFF
SETTING DATA* OFF
* = Plotter data only
Save data menu
3. Press the DELETE soft key. You are asked if you are ready to delete the memory card.
4. Push the ENTER knob to delete (or press the CLEAR key to escape). Do not remove
the card while its contents are being deleted. When the deleting is completed,
““COMPLETED DELETING USER DATA. PUSH ENTER KNOB TO CONTINUE.”
appears.
5. Push the ENTER knob to continue.
To Next Page
Loading...
Need help?
General
