7. CUSTOMIZING YOUR UNIT
7-29
2. Adjust the Trackball upward or downward to select Decca chain number.
3. Roll the Trackball rightward to show the display below, to enable selection of station
pair.
CHAIN STATION PAIR
S BALTIC
R-G01
▲
▼
▼
Decca chain and station pair window
4. Adjust the Trackball upward or downward
to select station pair (R: red, G: green and P:
purple).
5. Press the ENTER soft key to register your selection.
6. If necessary, you may enter position offset to refine Decca position. Select (CHAIN)
CORRECTION 1 or CORRECTION 2, then press the EDIT soft key. Enter correction
value with the Trackball and alphanumeric keys. Use the +
< − −> - soft key to switch
from plus to minus and vice versa. Press the ENTER soft key or push the ENTER knob.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key followed by the NEXT PAGE soft key.
9. Select “DECCA” from “TD DISPLAY” and “TD” from “POSITION DISPLAY.”
10. Press the MENU key twice to close the menu.
7.8 Nav Data Display Setup
The nav data display shows various navigation data, fed from a navigator, network
equipment, etc. You may select the data to display and where to display it as follows:
1. Press the MENU key to open the main menu.
2. Press the SYSTEM CONFIGURATION, SYSTEM SETUP, HOT PAGE & NAV DISP
SETUP and NAV DATA DISPLAY SETUP soft keys.
NAV
DATA
EDIT
RETURN
1 POSITION
2 WPT POS 3 SOG
4 STW 5 COG
6 BEARING 7 RANGE
8 DEPTH 9 TEMP
Nav data setup screen
To Next Page
Loading...
Need help?
General
