Revision L MAC™ 3500 Resting ECG Analysis System C-3
2021337-036
Electromagnetic Compatibility: Electromagnetic Compatibility (EMC)
Electromagnetic Compatibility (EMC)
Changes or modification to this system not expressly approved by GE Healthcare
could cause EMC issues with this or other equipment. This system is designed and
tested to comply with applicable regulation regarding EMC and needs to be installed
and put into service according to the EMC information stated as follows.
WARNING
Use of portable phones or other radio frequency (RF) emitting
equipment near the system may cause unexpected or adverse
operation.
WARNING
The equipment or system should not be used adjacent to, or
stacked with, other equipment. If adjacent or stacked use is
necessary, the equipment or system should be tested to verify
normal operation in the configuration in which it is being used.
Guidance and Manufacturer’s Declaration - Electromagnetic
Emissions
The MAC 3500 resting ECG analysis system is intended for use in the
electromagnetic environment specified below. It is the responsibility of the customer
or user to ensure that the MAC 3500 system is used in such an environment.
Emissions Test Compliance Electromagnetic Environment - Guidance
RF emissions
EN 55011
Group 1
The equipment uses RF energy only for its
internal function. Therefore, its RF emissions
are
very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
EN 55011
Class A
Class A Equipment is suitable for use in all
establishments other than domestic and those
directly connected to the public low-volta
ge
power supply network that supplies buildings
used for domestic purposes.
Harmonic Emissions
EN 61000-3-2
Class A
Voltage fluctuations/
Flicker emissions
EN 61000-3-3
Complies
To Next Page
Loading...
Need help?
General
