GE P50 Agile P253 User Manual

P50 Agile P253
5 Configuration
P253/EN M/C
5-35
SYSTEM CONFIG
Password protected window for
System Configuration
i.e. 2nd
Harmonic Disabled/Enabled, 2nd Harmonic Threshold and I>lift 2H.
Note: Setting will be seen only when it is enabled in Configuration
setting.
OVERCURRENT
Password protected window for Overcurrent
i.e. I>1 Function, I>2
Function and I>3 Function. The functions can be set as Disabled / DT /
IDMT.
Note: Setting will be seen only when it is enabled in Configuration
setting.
NEG SEQ O/C
Password protected window for Negative Sequence O/C
i.e. I2>1
Function, I2>2 Function and I2>3 Function. The functions can be set as
Disabled / DT / IDMT.
Note: Setting will be seen only when it is enabled in Configuration
setting.
EARTH FAULT 1
Password protected window for
Earth Fault 1
i.e. IN1>1 Function, IN1>2
Function and IN1>3 Function. The functions can be set as Disabled / DT
/ IDMT.
Note: Setting will be seen only when it is enabled in Configuration
setting.
EARTH FAULT 2
Password protected window for
Earth Fault 2
i.e. IN2>1 Function, IN2>2
Function and IN2>3 Function. The functions can be set as Disabled / DT
/ IDMT .
Note: Setting will be seen only when it is enabled in Configuration
setting.
THERMAL OVERLOAD
Password protected window for Thermal Overload i.e. Inh.Trip Dur ST,
K Coefficient, Thermal Trip, Thermal Alarm, Thermal Const. T1, Thermal
Const. T2, Cooling Const. Tr, Thermal Lockout and K.
Note: Setting will be seen only when it is enabled in Configuration
setting.
LOSS OF LOAD
Password protected window for Loss of Load i.e. I<1 Status
(Enabled/Disabled), I<1 Current Set, I<1 Time Delay, T inhib.
Note: Setting will be seen only when it is enabled in Configuration
setting.
CB FAIL
Password protected window for
CB FAIL
i.e. CB Fail Status, CB Fail
Timer, CBF Reset, CB Fail Timer, I<, IN<, Remove I> Start and Remove
IN> Start.
Note: Setting will be seen only when it is enabled in Configuration
setting.
STALL DETECTION
Password protected window for
Stall Detection
i.e. Start Criteria,
Prolonged Start (Starting Current and Prol. Start Time), Stall Rotor Strt
and Stall Detection (Stall Setting and Stall Time).
Note: Setting will be seen only when it is enabled in Configuration
setting.

GE P50 Agile P253 Specifications

General

Brand	GE
Model	P50 Agile P253
Category	Relays
Language	English