It refers to the port through which the client adds the device.
WebSocket Port
TCP-based full-duplex communication protocol port for plug-in free preview.
WebSockets Port
TCP-based full-duplex communication protocol port for plug-in free preview.
Certicate
verication is required to ensure the secure access.
ModbusTCP
It refers to the protocol through which the device transmits data, such as the
thermometry data.
Note
●
WebSocket Port, and WebSockets Port are only supported by certain models.
●
For device models that support that function, go to
Conguration > Network > Advanced
Settings > Network Service to enable it.
3.3 Port Mapping
By setting port mapping, you can access devices through the specied port.
Before You Start
When the ports in the device are the same as those of other devices in the network, refer to
Port
to modify the device ports.
Steps
1.
Go to Conguration > Network > Basic Settings > NAT .
2.
Select the port mapping mode.
Auto Port Mapping
Refer to
Set Auto Port Mapping
for detailed information.
Manual Port Mapping Refer to
Set Manual Port Mapping
for detailed information.
3.
Click Save.
3.3.1 Set Auto Port Mapping
Steps
1.
Check Enable UPnP™, and choose a friendly name for the camera, or you can use the
default name.
2.
Select the port mapping mode to Auto.
3.
Click Save.
Note
UPnP™ function on the router should be enabled at the same time.
Thermal & Optical Bi-spectrum Network Camera User Manual
8
To Next Page
Loading...
Need help?
General
