Picture Quality
Set quality of the alarm capture. The better the quality is, the sharper
the image is, and the larger the
le size is.
Fire Source Detection
Dynamic Fire detects the dynamic re source and Smoking Mode
detects the smoking behavior in the scene.
Note
Smoking Mode is not supported in Fire and Smoke and Double
Conrm.
Display Fire Source Frame on Stream
Display a red frame around the re source on stream when re
occurs.
Sensitivity
The higher the value is, the more easily the re source of lower
temperature can be detected, and the higher the false alarm rate is.
Smoke
Detection
Display Smoke Source Frame on Stream
Display a red frame around the smoke source on stream when
smoke occurs.
Sensitivity
The higher the value is, the more easily the smoke can be detected,
and the higher the false alarm rate is.
Verication Sensitivity
The higher the value is, the more quickly the device can double-check
and identify the smoke, and the higher the false alarm rate is.
5.
Optional: Go to Smart Event > Smoke Detection Shield . You can shield certain areas
from being detected in smoke detection, refer to
Set Detection Shield Region
.
6.
Refer to
Set Arming Schedule
for setting scheduled time. Refer to
Linkage Method
Settings
for setting linkage method.
7.
Click Save.
7.2.3 Set Dynamic Fire Source Detection
To avoid the potential
re damage, you can congure the re detection function for certain
areas. The detail
conguration steps show as below.
Before You Start
Go to Conguration > System > Maintenance > VCA Resource Type , select Temperature
Measurement + Perimeter Protection.
Thermal & Optical Bi-spectrum Network Camera User Manual
64
To Next Page
Loading...
Need help?
General
