3.3.2 Set Manual Port Mapping
Steps
1.
Check Enable UPnP™, and choose a friendly name for the device, or you can use the
default name.
2.
Select the port mapping mode to Manual, and set the external port to be the same as the
internal port.
3.
Click Save.
What to do next
Go to the router port mapping settings interface and set the port number and IP address to
be the same as those on the device. For more information, refer to the router user manual.
3.4 Multicast
Multicast is group communication where data transmission is addressed to a group of
destination devices simultaneously. After setting multicast, you can send the source data
efciently to multiple receivers.
Go to Conguration > Network > Basic Settings > Multicast for the multicast settings.
IP Address
It stands for the address of multicast host.
Stream Type
The stream type as the multicast source.
Video Port
The video port of the selected stream.
Audio Port
The audio port of the selected stream.
Note
Audio Port varies according to different camera models.
3.5 SNMP
You can set the SNMP (Simple Network Management Protocol) to get device information
in network management.
Before You Start
Before setting the SNMP, you should download the SNMP software and manage to receive
the device information via SNMP port.
Thermal & Optical Bi-spectrum Network Camera User Manual
9
To Next Page
Loading...
Need help?
General
