Chapter 8 Event and Alarm
This part introduces the
conguration of events. The device takes certain response to
triggered alarm. Certain events may not be supported by certain device models.
8.1 Set Motion Detection
It helps to detect the moving objects in the detection region and trigger the linkage actions.
Steps
1.
Go to
Conguration > Event > Basic Event > Motion Detection .
2.
Select the channel No.
3.
Check Enable Motion Detection.
4.
Optional: Highlight to display the moving object in the image in green.
1)Check Enable Dynamic Analysis for Motion.
2)Go to
Conguration > Local .
3)Set Rules to Enable.
5.
Select
Conguration Mode, and set rule region and rule parameters.
-
For the information about normal mode, see
Normal Mode
.
-
For the information about expert mode, see
Expert Mode
.
6.
Set the arming schedule and linkage methods. For the information about arming
schedule settings, see
Set Arming Schedule
. For the information about linkage
methods, see
Linkage Method Settings
.
7.
Click Save.
8.1.1 Normal Mode
You can set motion detection parameters according to the device default parameters.
Steps
1.
Select normal mode in Conguration.
2.
Set the sensitivity of normal mode. The higher the value of sensitivity is, the more
sensitive the motion detection is. If the sensitivity is set to
0
, motion detection and
dynamic analysis do not take effect.
3.
Set Detection Target. Human and vehicle are available. If the detection target is not
selected, all the detected targets will be reported, including the human and vehicle.
4.
Click Draw Area. Click and drag the mouse on the live video, and then release the mouse
to
nish drawing one area.
Stop Drawing
Stop drawing one area.
Clear All Clear all the areas.
5.
Optional: You can set the parameters of multiple areas by repeating the above steps.
Thermal & Optical Bi-spectrum Network Camera User Manual
76
To Next Page
Loading...
Need help?
General
