HIKVISION DS-2TD2637-7/QY User Manual

Steps
1.
Go to
Conguration > Network > Advanced Settings > SNMP .
2.
Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
The SNMP version you select should be the same as that of the SNMP software.
And you also need to use the different version according to the security level required.
SNMP v1 is not secure and SNMP v2 requires password for access. And SNMP v3
provides encryption and if you use the third version, HTTPS protocol must be enabled.
3.
Congure the SNMP settings.
4.
Click Save.
3.6 Access to Device via Domain Name
You can use the Dynamic DNS (DDNS) for network access. The dynamic IP address of the
device can be mapped to a domain name resolution server to realize the network access
via domain name.
Before You Start
Registration on the DDNS server is required before
conguring the DDNS settings of the
device.
Steps
1.
Refer to TCP/IP to set DNS parameters.
2.
Go to the DDNS settings page:
Conguration > Network > Basic Settings > DDNS .
3.
Check Enable DDNS and select DDNS type.
DynDNS
Dynamic DNS server is used for domain name resolution.
NO-IP
NO-IP server is used for domain name resolution.
4.
Input the domain name information, and click Save.
5.
Check the device ports and complete port mapping. Refer to
Port to check the device
port, and refer to
Port Mapping for port mapping settings.
6.
Access the device.
By Browsers
Enter the domain name in the browser address bar to access the
device.
By Client Software Add domain name to the client software. Refer to the client
manual for
specic adding methods.
Thermal & Optical Bi-spectrum Network Camera User Manual
10

HIKVISION DS-2TD2637-7/QY Specifications

General

Brand	HIKVISION
Model	DS-2TD2637-7/QY
Category	Security Camera
Language	English