94 Solaris 7980g User Guide
Codabar Concatenation
Codabar supports symbol concatenation. When you enable concatenation, the
scanner looks for a Codabar symbol having a “D” start character, adjacent to a
symbol having a “D” stop character. In this case the two messages are concate-
nated into one with the “D” characters omitted.
Select Require to prevent the scanner from decoding a single “D” Codabar symbol
without its companion. This selection has no effect on Codabar symbols without
Stop/Start D characters.
Codabar Redundancy
If you are encountering errors when reading Codabar bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the following Codabar Redundancy bar code, then
scan a redundancy count between 0 and 10 on the Programming Chart. Scan Save.
Default = 0.
Validate Modulo 16
and Transmit
To Next Page
Loading...
Need help?
General
Weight and Dimensions
