52 Solaris 7980g User Guide
High Priority Symbology
To specify the high priority symbology, scan the High Priority Symbology bar code
below. On the Symbology Charts, find the symbology you want to set as high prior-
ity. Locate the Hex value for that symbology and scan the 2 digit hex value from the
Programming Chart. Scan Save to save your selection. Default = None
Low Priority Symbology
To specify the low priority symbology, scan the Low Priority Symbology bar code
below. On the Symbology Charts, find the symbology you want to set as low priority.
Locate the Hex value for that symbology and scan the 2 digit hex value from the
Programming Chart.
If you want to set additional low priority symbologies, scan FF, then scan the 2 digit
hex value from the Programming Chart for the next symbology. You can program
up to 5 low priority symbologies. Scan Save to save your selection. Default = None
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low priority
symbologies, you must set the time-out period. This is the period of time the scan-
ner will search for a high priority bar code after a low priority bar code has been
encountered. Scan the bar code below, then set the delay (from 1-3,000 millisec-
onds) by scanning digits from the Programming Chart, then scanning Save.
Default = 500 ms.
* Preferred Symbology Off
Preferred Symbology Time-out
To Next Page
Loading...
Need help?
General
Weight and Dimensions
