100 Solaris 7980g User Guide
Interleaved 2 of 5 Redundancy
If you are encountering errors when reading Interleaved 2 of 5 bar codes, you may
want to adjust the redundancy count. Redundancy adjusts the number of times a
bar code is decoded before transmission, which may reduce the number of errors.
Note that the higher the redundancy count, the longer it will take to decode the bar
code. To adjust the redundancy, scan the Interleaved 2 of 5 Redundancy bar code
below, then scan a redundancy count between 0 and 10 on the Programming
Chart. Scan Save. Default = 0.
Interleaved 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 92) for additional information. Minimum and Maximum lengths
= 2-80. Minimum Default = 4, Maximum Default = 80.
NEC 2 of 5
< Default All NEC 2 of 5 Settings >
Validate, but Don’t Transmit
Interleaved 2 of 5
Redundancy