Solaris 7980g User Guide 73
Step 6. Editor Commands
Refer to Data Format Editor Commands (page 74). Scan the symbols that
represent the command you want to enter.
Step 7. Scan Save to save your data format, or Discard to exit without saving your
changes.
Other Programming Selections
• Clear One Data Format
This deletes one data format for one symbology. If you are clearing the primary
format, scan 0 from the Programming Chart. If you are clearing an alternate
format, scan 1, 2, or 3, depending on the format you are clearing. Scan the
Terminal Type and Code I.D. (see Symbology Charts on page 221), and the bar
code data length for the specific data format that you want to delete. All other
formats remain unaffected.
• Clear all Data Formats
This clears all data formats.
• Save to exit and save your data format changes.
• Discard to exit without saving any data format changes.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
