HP 8590 L-Series User Manual

hp
REF
\ “” _ - - ‘“’
10 dB
-i? 91 Iii
3
? Ml/R ‘1<,1 c1 ““Hz
~iy?y$j
dB/ 1 l\l \I I I I I I I I
WA VB
VC FC
\
CORR
I I
I I I
CENTER 300 0 MHz
SPAN 200.0 MHz
#RES BW 3 MHz
VBW 300 kHz
SWP 20 m5eiI
Figure 5-4. Typical Limit-Line Display
5. Press Edit Limit then Edit Upper to create an upper limit line.
The table defaults to frequency parameters, the second column should be labeled
START-FREQ. If it is labeled START-TIME, press More 1 of 2, EDIT DONE, and
Edit Limit . Press LIMITS FRQ TIME so that FRQ is underlined. LIMITS FRQ TIME
specifies that the limit line parameters be entered in either frequency or time.
Note
To clear an existing limit-line table, press More 1 of 2 . Then press
PURGE LIMITS two times.
After pressing PURGE LIMITS the first time, the message If you are sure,
press key again to purge data will appear. Pressing PURGE LIMITS a second
time purges the limit-line table. fjj) turns limit-line testing off (if it is on),
but does not clear an existing limit-line table.
6. Press Edit Upper to edit or create an upper limit line.
Using Analyzer Features 5-19

HP 8590 L-Series Specifications

General

Brand	HP
Model	8590 L-Series
Category	Measuring Instruments
Language	English