112 HP ProLiant DL360 Generation 4 Server Reference and Troubleshooting Guide
Internal System Problems
List of Problems:
CD-ROM and DVD Drive Problems..........................................................................................112
DAT Drive Problems..................................................................................................................113
Diskette Drive Problems.............................................................................................................114
DLT Drive Problems ..................................................................................................................116
Fan Problems..............................................................................................................................118
Hard Drive Problems..................................................................................................................119
Memory Problems ......................................................................................................................121
PPM Problems............................................................................................................................124
Processor Problems.....................................................................................................................124
CD-ROM and DVD Drive Problems
List of Problems:
System does not boot from the drive..........................................................................................112
Data read from the drive is inconsistent, or drive cannot read data............................................113
Drive is not detected...................................................................................................................113
System does not boot from the drive
Action:
1. Be sure the drive boot order in RBSU is set so that the server boots from the
CD-ROM drive first.
2. If the CD-ROM drive jumpers are set to Cable Select (the factory default), be
sure the CD-ROM drive is installed as device 0 on the cable so that it is in
position for the server to boot from the drive.
3. Be sure no loose connections (on page 108
) exist.
4. Be sure the media from which you are attempting to boot is not damaged and
is a bootable CD.
5. If attempting to boot from a USB CD-ROM drive:
− Refer to the operating system and server documentation to be sure both
support booting from a USB CD-ROM drive.
− Be sure legacy support for a USB CD-ROM drive is enabled in RBSU.
To Next Page
Loading...
Need help?
General