186 HP ProLiant DL360 Generation 4 Server Reference and Troubleshooting Guide
Wrong Accelerator
Description: This may mean that the board was replaced in the wrong slot or
was placed in a system previously configured with another board type. Included
with this message is a message indicating (1) the type of adapter sensed by ADU,
and (2) the type of adapter last configured in EISA NVRAM.
Action: Check the diagnosis screen for other error messages. Run the server
setup utility to update the system configuration.
POST Error Messages and Beep Codes
List of Messages:
Introduction to POST Error Messages........................................................................................186
Non-Numeric Messages or Beeps Only .....................................................................................187
100 Series ...................................................................................................................................197
200 Series ...................................................................................................................................200
300 Series ...................................................................................................................................205
400 Series ...................................................................................................................................206
600 Series ...................................................................................................................................207
1100 Series .................................................................................................................................209
1600 Series .................................................................................................................................210
Introduction to POST Error Messages
The error messages and codes in this section include all messages generated by
ProLiant servers. Some messages are informational only and do not indicate any
error. A server generates only the codes that are applicable to its configuration
and options.
HP ProLiant BL servers do not have speakers and thus do not support audio
output. Disregard the audible beeps information if the server falls into this
category.
IMPORTANT: This guide provides information for multiple servers.
Some information may not apply to the server you are troubleshooting.
Refer to the server documentation for information on procedures,
hardware options, software tools, and operating systems supported by
the server.
To Next Page
Loading...
Need help?
General