100
Chapter 5: Using Debuggers
Using the Green Hills Debugger
and run from the start, click restart.
To send commands to the emulation probe/
module
MULTI communicates with the emulation probe/module using the
emulation probe/module’s “terminal interface” commands. MULTI
automatically generates and sends the commands required for normal
operation.
If you want to communicate directly with the emulation probe/module
during a debug session, you may do so using “terminal interface”
commands through the Target window (which comes up when hpserv
is brought up).
You can also enter terminal interface commands from the Debugger
window’s command pane by preceding the command with the “target”
command.
To view commands sent by MULTI to the
emulation probe/module
The communication between MULTI and the emulation probe/module
can be viewed by running hpserv in a logging mode:
remote hpserv -dc -a -o <filename> <emulation probe/
module name>
The options -dc and -da log both asynchronous and console messages
and the -o <filename> directs these messages to a log file called
<filename>. When using this option, disconnect from hpserv (to flush
out the file) and then you may view <filename> to see what commands
MULTI sent to the emulation probe/module.
NOTE: Logging commands in this way may result in a VERY large file. Beware of the
disk space it may require.
To Next Page
Loading...
Need help?
General
