57
Chapter 2: Installing the Emulation Module
Updating Emulation Module Firmware
workspace.
3 Install the processor support package from the CD-ROM, if
necessary.
4 In the system window, click the emulation module and select
Update Firmware.
5 In the Update Firmware window, select the firmware to load into
the emulation module.
6 Click Update Firmware.
In about 20 seconds, the firmware will be installed and the screen will
update to show the current firmware version.
See also “Installing Software” on page 54 for instructions on how to install the
processor support package from the CD-ROM.
To update firmware using the Setup Assistant
The Setup Assistant is an on-line tool for connecting and configuring
your logic analysis system for microprocessor and bus analysis. The
Setup Assistant is available on the HP 16600A/16700A-series logic
analysis systems.
This menu-driven tool will guide you through the connection
procedures for connecting the logic analyzer to an analysis probe, an
emulation module, or other supported equipment. It will also guide you
through connecting an analysis probe to the target system.
1 Install the processor support package from the CD-ROM.
To Next Page
Loading...
Need help?
General
