5
Contents
Emulation for the PowerPC MPC500—At a Glance
Emulation Probe 3
Emulation Module 3
In This Book
1 Installing the Emulation Probe
Overview of Installation and Setup 14
Equipment and Requirements 16
Supplied Equipment and Software 16
Additional Equipment and Software Required 17
Other Optional Equipment 18
Powering-On and Powering-Off the Emulation Probe 19
To power on the system 19
To power off the system 19
To connect the emulation probe to a power source 19
Connecting the Emulation Probe to a LAN 21
To get the IP and gateway addresses 22
To configure LAN parameters using the built-in terminal interface 23
To configure LAN parameters using BOOTP 26
To set the 10BASE-T configuration switches 28
To verify LAN communications 29
Solving LAN Communication Problems 31
If you cannot verify LAN communication 31
If you have LAN connection problems 32
If the “POL” LED is lit 33
If it takes a long time to connect to the network 33
To Next Page
Loading...
Need help?
General
