14
Chapter 1: Installing the Emulation Probe
Overview of Installation and Setup
Overview of Installation and Setup
Follow these steps to connect your equipment.
1 Check that you received all of the necessary equipment. See
“Equipment and Requirements” on page 16.
2 Disconnect power from the target system, emulation probe, and
logic analyzer before you make or break connections. See
“Powering-On and Powering-Off the Emulation Probe” on
page 19.
3 Connect the emulation probe to a LAN. See “Connecting the
Emulation Probe to a LAN” on page 21.
4 Update the emulation probe’s firmware to give it the proper
“personality” for the microprocessor it will connect to. See
“Updating Emulation Probe Firmware” on page 40.
5 Connect the emulation probe to your target system. See the
“Connecting to a Target System” chapter on page 63.
6 Configure the emulation probe. See the “Configuring the
Emulation Probe/Module” chapter on page 75.
To Next Page
Loading...
Need help?
General
