54
Chapter 2: Installing the Emulation Module
Installing Software
Installing Software
This chapter explains how to install the software you will need for your
emulation module.
Installing and loading
Installing the software will copy the files to the hard disk of your logic
analysis system. Later, you will need to load some of the files into the
appropriate hardware module.
What needs to be installed
If you ordered an emulation module with your logic analysis system,
the software was installed at the factory.
The following files are installed from the CD-ROM:
• Emulation module firmware.
• Emulation Control Interface.
To install software from CD-ROM
Installing a processor support package from a CD-ROM will take just a
few minutes. If the processor support package requires an update to
the HP 16600A/16700A-series logic analysis system’s operating system,
installation may take approximately 45 minutes.
CD-ROM or
flexible disk
Install Load
Hard Disk
Logic analyzer
or emulation
module
Logic analysis system or logic analyzer frame
To Next Page
Loading...
Need help?
General
