System summary 25
System settings
In the Configure system settings area, you can specify information that helps identify the
AP:
System name
Specify a name.
System location
Provide a description that identifies where the M210 is physically located.
System contact
Specify a person to contact for administrative purposes.
Multiple RADIUS servers
If you select 802.1X/Dynamic WEP or WPA/WPA2 Enterprise as the Security
method, you can configure multiple RADIUS servers on this page (in the Quick setup wizard
you can configure only one).
System summary
After you complete the Quick setup wizard, when you log into the management tool again, the
System summary page displays.
This page includes the following information:
IP address
The IP address assigned to the AP. See the Network > IP page to configure IP information.
Static IPv6 address
The IPv6 address assigned to the AP, if one is configured.
IPv6 autoconfigured global addresses
The global IPv6 address, if one or more has been assigned automatically using the network
prefix that is sent by routers in router advertisements.
IPv6 link local address
The link local address is derived automatically using the prefix fe80::/64 and the MAC
address of the AP.
To Next Page
Loading...
Need help?
General
