Client connections 85
Removing an AP from the cluster
To remove an AP from the cluster:
1. On the M210 that you want to remove from the cluster, select Cluster > Access points.
2. For the Clustering setting, select Disabled, then select Save.
Client connections
From any AP in a cluster, you can select Cluster > Client connections to view information
about clients connected to any clustered AP.
Note This page displays data only if clustering is enabled on the Cluster > Configuration page.
Information shown in tables can be sorted by selecting the desired column label.
Note This page shows a maximum of 20 clients on each clustered AP. To see all clients associated
with a particular AP, view the Wireless > Client connections page directly on that AP.
AP MAC
Media Access Control (MAC) address of the AP.
The address shown here is the MAC address for the Ethernet interface and the default wireless
community (wlan0). This is the address by which the AP is known externally to other networks.
Station MAC
The Media Access Control (MAC) address of the client.
Idle
The time in seconds that has elapsed since the last client activity.
Rate (Mbps)
The speed in Mbps at which this AP is transferring data to the specified client. This value should
fall within the range of the advertised rate set for the mode in use on the AP. For example, 6 to
54 Mbps for 802.11a.
To Next Page
Loading...
Need help?
General
