MSM410
Hardware overview
2-5
Once the discovery process is complete, and the MSM410 has established a secure
management tunnel to a controller, the Power light remains on and the Ethernet and Radio
lights blink to indicate the presence of traffic.
Ports
The MSM410 provides two ports.
Ethernet port: Auto-sensing 10/100/1000 BaseT Ethernet port with an RJ-45 connector.
The port supports Power over Ethernet (PoE) 802.3af.
Console port: Standard console (serial) port with an RJ-45 connector. For details, see
Console Ports in the MSM3xx / MSM4xx Access Points Management and Configuration
Guide.
Warning Never connect the Console port to an Ethernet switch or PoE power source. This may
damage the MSM410. Connect it only to other serial ports via an RJ-45 to DB-9 adapter.
Radio and antenna
The MSM410 contains an integrated single 802.11n/a/b/g radio with an internal three-element,
dual-band, MIMO antenna.
Reset button
The Reset button is accessible via a hole on the bottom of the MSM410 as identified below.
Insert a paper clip under the cable and into the reset button hole at the precise angle shown.
Press and quickly release the button to reset the MSM410.
To reset the MSM410 to factory defaults, press the button until the status lights blink
three times, then release. Following a reset to factory defaults, the MSM410 starts up in
controlled mode.
To Next Page
Loading...
Need help?
General
