MSM310
Important information to read before installing
4-4
Ethernet ports
The MSM310 has two 10/100 Mbps Ethernet ports with RJ-45 connectors. Port 1 supports
Power over Ethernet (PoE) 802.3af. In controlled mode, Port 1 should be used. In
autonomous mode, Port 1 or Port 2 can be used.
Reset button
Press and quickly release the button to reset the MSM310.
To reset to factory default settings, press and hold the reset button until the status lights
flash three times, then release. Following a reset to factory defaults, the MSM310
starts up in controlled mode.
Note To reconnect to the management tool after a factory reset, your computer must be connected
to Ethernet Port 1.
Radios and antennas
The MSM310 has a single radio, with two antennas for diversity.
The antenna connectors are reverse-polarity SMA jacks. Antennas or cable connectors must
use RP-SMA plugs. Antennas can be mounted directly on the MSM310. When a single antenna
is used per radio, it is recommended to connect it to the Main antenna connector.
Note Optional external antennas are available from HP.
Important information to read before
installing
For indoor installation only.
PROFESSIONAL INSTALLATION REQUIRED
Prior to installing or using the MSM310, consult with a professional installer trained in RF
installation and knowledgeable in local regulations including building and wiring codes,
safety, channel, power, indoor/outdoor restrictions, and license requirements for the intended
country. It is the responsibility of the end user to ensure that installation and use comply with
local safety and radio regulations.
To Next Page
Loading...
Need help?
General
