MSM310-R
Installation
5-8
7. Remove the white backing paper from one of the RJ-45 Gaskets (8) and press the glued
side onto the Body (6) being very careful to align the gasket with the RJ-45 connector
shape on the Body (6).
8. Remove the backing paper from the second RJ-45 Gasket (8) and press it over the first
one, being sure to maintain alignment.
9. Tighten the threads between Body (6) and Clamp Ring (3) by hand. DO NOT tighten
between Clamp Ring (3) and Sealing Nut (1). Do not over tighten. Do not tighten
with tools.
The quick-disconnect assembly should now look like this when held horizontally, with
the Sealing Nut (1) at the left end, and the Screw Nut (5) over the Body (6) on the right.
10. Carefully thread the cleanly-cut end of the Ethernet cable through the Sealing Nut (1) end
of the quick-disconnect assembly, and push through approximately 30 cm (1 foot) of
cable.
Note The next two steps should be performed by someone with experience building Ethernet
cables.
11. Prepare the cable and attach it to the RJ-45 Plug (7) according to the directions included
with your crimping tool.
12. Before continuing, test the cable with a portable Ethernet cable tester to ensure that the
RJ-45 plug (7) is correctly connected.
13. Carefully pull the cable slack back through the quick-disconnect assembly until the RJ-45
Plug (7) is almost touching the Body (6). Adjust the cable position so that the RJ-45 Plug
(7) fits precisely into the RJ-45 cutout in the Body (6), and press down the plastic tab so
the plug fits correctly.
14. Tighten the threads between Sealing Nut (1) and Clamp Ring (3) by hand, until the cable
is firmly anchored. Do not over tighten. Do not tighten with tools.
Step 4: Install the MSM310-R
1. Mount the MSM310-R on a wall or pole using the supplied brackets so that the antennas
are pointing up. Local electrical and building codes will dictate many installation aspects.
2. Attach the supplied grounding lug (through the bracket) to one of the lower screw holes
on the MSM310-R body, and attach a grounding wire with the set screw.
(See figure in sub-step 4 below: “Grounded body (via grounding lug).”)
To Next Page
Loading...
Need help?
General
