MSM410
Initial configuration (autonomous mode)
2-10
Note Do not power-on the MSM410 until directed.
Step 1: Configure your computer
1. Disconnect your computer LAN port and configure it to use a static IP address in the
range 192.168.1.2 to 192.168.1.254, and a subnet mask of 255.255.255.0. Set the
default gateway to 192.168.1.1, and DNS server to 192.168.1.1. For example to do this
in Windows Vista, use Control Panel > Network and Sharing Center > Manage
Network Connections > Local Area Connection, right-click Properties then select
Internet Protocol Version 4 (TCP/IPv4) > Properties.
2. Disable any wireless connection on your computer.
Step 2: Connect the cables and power on the MSM410
1. Connect the cables:
If using a PoE switch, use Ethernet cables to connect your computer and the MSM410
to an unused factory-default PoE switch.
If using a PoE injector, use Ethernet cables to connect your computer to the data in
port of the PoE injector and the MSM410 to the data and power out port of the PoE
injector.
2. Power on the MSM410 by powering on the PoE switch or injector.
Initially, the MSM410 power light will blink once every two seconds. Wait approximately a
minute until it begins blinking once per second before proceeding to the next step.
Step 3: Switch the MSM410 to autonomous mode
Note A factory-default MSM410 is assumed.
1. In a Web browser, enter the address: https://192.168.1.1.
2. A security certificate warning is displayed the first time you connect to the management
tool. This is normal. Select whatever option is needed in your Web browser to continue to
the management tool. The security warning will not appear again unless you change the
IP address of the MSM410.
3. On the Login page, specify admin for both Username and Password and then select
Login. The MSM410 management tool home page opens.
4. Select Switch to Autonomous Mode and confirm the change. The MSM410 restarts in
autonomous mode.
To Next Page
Loading...
Need help?
General
