MSM410
Important information to read before installing
2-6
Important information to read before installing
For indoor installation only.
PROFESSIONAL INSTALLATION REQUIRED
Prior to installing or using the MSM410, consult with a professional installer trained in RF
installation and knowledgeable in local regulations including building and wiring codes,
safety, channel, power, indoor/outdoor restrictions, and license requirements for the intended
country. It is the responsibility of the end user to ensure that installation and use comply with
local safety and radio regulations.
Cabling
You must use the appropriate cables, and where applicable, surge protection, for your given
region. For compliance with EN55022 Class-B emissions requirements, use shielded Ethernet
cables. Cables with large boots may not insert into the RJ-45 connectors properly. It is
recommended that you do not use such cables. Cat 5e (or better) cabling is required.
Plenum installation
The MSM410 and appropriate cabling can be installed in a plenum. The MSM410 is suitable
for use in environmental air space in accordance with Section 300-22(C) of the National
Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian Electrical Code,
Part 1, CSA C22.1.
The MSM410 should be installed with its top surface facing the floor (similar orientation as in
a ceiling installation). However, it is left to a qualified installer to determine how to install/
secure the MSM410 in a plenum in an appropriate and safe manner. Plenum-rated cables and
attachment hardware must be used.
Country of use
In some regions, you are prompted to select the country of use during setup. Once the
country has been set, the MSM410 will automatically limit the available wireless channels,
ensuring compliant operation in the selected country. Entering the incorrect country may
result in illegal operation and may cause harmful interference to other systems.
Safety
Take note of the following safety information during installation.
If your network covers an area served by more than one power distribution system, be
sure all safety grounds are securely interconnected.
Network cables may occasionally be subject to hazardous transient voltages (caused by
lightning or disturbances in the electrical power grid).
To Next Page
Loading...
Need help?
General
