Computer Setup—Power
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-3 Computer Setup—Power
Option Description
After AC Power
Failure
Allows you to select system restart behavior after power loss:
●
Stay Off (default)
●
Power On
●
Auto
XD(Execute Disable) Disables/enables XD bit. Default is enabled.
Virtualization
Technology
Allows you to enable/disable the virtualization features of the processor. Changing this setting
requires turning the computer off and then back on. Default is disabled.
WOL in S5 Allows you to enable/disable limited (normal shutdown) WOL from S5 support. Default is disabled.
Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-4 Computer Setup—Boot
Option Description
Boot-time Diagnostic
Screen
Disables/enables POST diagnostic messages display. Default is disabled.
ESC: Boot Menu Enables/disables the ability to press the Esc key to access the boot menu during boot.
F9: Diagnostics Enables/disables the ability to press the F9 key to access the Diagnostics menu during boot.
F10: Setup Enables/disables the ability to press the F10 key to access the Setup menu during boot.
F11: Recovery Enables/disables the ability to press the F11 key to access the recovery menu during boot.
F12: Boot from LAN Enables/disables the ability to press the F12 key to boot from LAN.
Boot Device Priority
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
Allows you to specify which device groups will boot first, second, third, and fourth or to disable any
of the four:
●
Floppy Group
●
CD-ROM Group
●
Hard Drive Group
●
Network Boot Group
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating system
has started.
Computer Setup (F10) Utilities
11
To Next Page
Loading...
Need help?
General
