Stand Bracket
The stand bracket is secured with four screws. Removing it allows access to the fans, heat sink,
processor, and optional TV tuner.
To remove the stand bracket:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer on page 28).
2. Remove the small rear cover (see
Small Rear Cover on page 29).
3. Remove the stand (see
Stand on page 30).
4. Remove the right rear cover (see
Right Rear Cover on page 36).
5. Remove the heat sink (see
Heat Sink (Thermal Module) on page 39).
6. Remove the rear cover (see
Rear Cover on page 47).
7. Remove the four screws (1) that secure the bracket to the computer.
8. Lift the bracket from the computer (2).
Figure 7-28 Removing the stand bracket
To replace the stand bracket, reverse the removal procedures.
Stand Bracket
59
To Next Page
Loading...
Need help?
General
