Step 8 Use a Phillips screwdriver to tighten the screws. See step (2) in Figure 7-52.
NOTE
If fan modules have been installed, remove them and the fan support before tightening the screws.
Step 9 Connect the cables from the DVD drive to the mainboard and the front disk backplane. For
details, see 2.7 Internal Cabling.
Step 10 Install the fan module brackets in the chassis. See Figure 7-53.
Figure 7-53 Installing fan module brackets
Step 11 Install the fan modules. For details, see 7.16 Installing a Fan Module.
Step 12 Install the air duct. For details, see 7.14 Installing the Air Duct.
Step 13 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 14 Install the RH2288 V3. For details, see 3.4 Installing the Server.
Step 15 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 16 Power on the RH2288 V3. For details, see 4.1 Powering On the Server.
----End
7.25 Removing the Internal USB Flash Drive
Remove the USB flash drive before replacing it with a new one.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 175
To Next Page
Loading...
Need help?
General