Figure 7-109 Removing an SD card
Step 13 Remove the SD card. See step (2) in Figure 7-109.
Step 14 Place the removed SD card in an ESD bag.
----End
7.48 Installing an SD Card
Install an SD card if an SD card has failed or needs to be replaced with a new model.
The server can be installed with one or two SD cards, which are monitored by the iBMC. If
the iBMC detects two SD cards when completing initialization, the iBMC automatically
configures the two SD cards as a RAID 1 array. You can view information about the SD cards
and RAID 1 array on the iBMC WebUI by choosing System Info > Other. However, you
cannot modify the configuration.
The two SD cards in the RAID 1 array are mirrored with each other. If the SD card to be
installed contains data, data overwriting will occur. Therefore, before installing an SD card,
ensure that the SD card contains no data.
NOTE
After replacing the faulty SD card, wait for at least 60 minutes for the RAID 1 rebuild to complete.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 227
To Next Page
Loading...
Need help?
General