Figure 7-117 Installing the disk backplane
NOTE
After dual RAID controller cards are configured, the indicator of the rear hard disk module can be
configured only when the CPLD version of the front disk backplane is later than V1.08.
Step 5 Connect the cable of the front hard disk to the server. For details, see 2.7 Internal Cabling.
Step 6 Install the front disks.
Step 7 Install the fan module bracket.
Step 8 Install the fan modules. For details, see 7.16 Installing a Fan Module.
Step 9 Install full-height full-length riser cards if they are required. For details, see 7.19 Removing
the Riser Card.
Step 10 Install the air duct. For details, see 7.14 Installing the Air Duct.
Step 11 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 12 Install the RH2288 V3. For details, see 3.4 Installing the Server.
Step 13 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 14 Power on the RH2288 V3. For details, see 4.1 Powering On the Server.
----End
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 236
To Next Page
Loading...
Need help?
General