Husqvarna FE 350 EU User Manual

10 SERVICE SCHEDULE 32
10.1 Service schedule
Every 30 operating hours/after every race
Every 15 operating hours
Once after 1 operating hour
Read out the fault memory using the Husqvarna diagnostics tool. x ○ ● ●
Check that the electrical equipment is functioning properly. ○ ● ●
Check and charge the battery. x ● ●
Check the front brake linings. ( p. 67) ● ●
Check the rear brake linings. ( p. 71) ● ●
Check the brake discs. ( p. 66) ● ●
Check the brake lines for damage and leakage. ● ●
Check the rear brake fluid level. ( p. 70) ● ●
Check the free travel of the foot brake lever. ( p. 69) ● ●
Check the frame and swingarm. x ● ●
Check the swingarm bearing. x ●
Check the heim joints at the top of the shock absorber. x ● ●
Check the tire condition. ( p. 76) ○ ● ●
Check the tire air pressure. ( p. 77) ○ ● ●
Check the wheel bearing for play. x ● ●
Check the wheel hubs. x ● ●
Check the rim run-out. x ○ ● ●
Check the spoke tension. ( p. 77) ○ ● ●
Check the chain, rear sprocket, engine sprocket and chain guide. ( p. 60) ● ●
Check the chain tension. ( p. 59) ○ ● ●
Grease all moving parts (e.g., side stand, hand lever, chain, ...) and check for smooth operation. x ● ●
Check/rectify the fluid level of the hydraulic clutch. ( p. 63) ● ●
Check the front brake fluid level. ( p. 66) ● ●
Check the free travel of the hand brake lever. ( p. 65) ● ●
Check the steering head bearing play. ( p. 46) ○ ● ●
Check the valve clearance. x ○ ●
Check the clutch. x ●
Change the shaft seal rings of the water pump. x ●
Change the engine oil and oil filter, clean the oil screen. x ( p. 92) ○ ● ●
Check all hoses (e. g., fuel, cooling, bleeding, drainage) and sleeves for cracking, leaks, and incorrect routing. x ○ ● ●
Check the antifreeze and coolant level. ( p. 86) ○ ● ●
Check the cables for damage and routing without sharp bends. x ● ●
Check that the cables are undamaged, routed without sharp bends and set correctly. ○ ● ●
Clean the air filter and air filter box. x ● ●
Change the glass fiber yarn filling of the main silencer. x ( p. 54) ●
Check the screws and nuts for tightness. x ○ ● ●
Check the headlight setting. ( p. 84) ○ ● ●
Change the fuel screen. x ( p. 91) ○ ● ●
Check the fuel pressure. x ● ●
Adjust the idle speed. x ( p. 90) ○ ● ●
Check that the radiator fan is functioning properly. x ○ ● ●
Final check: Check the vehicle for roadworthiness and take a test ride. ○ ● ●
Read out the fault memory using the Husqvarna diagnostics tool after a test ride. x ○ ● ●
Make the service entry in Husqvarna Dealer.net and in the service booklet. x ○ ● ●
○ One-time interval

Husqvarna FE 350 EU Specifications

General

Brand	Husqvarna
Model	FE 350 EU
Category	Motorcycle
Language	English