18 SERVICE WORK ON THE ENGINE 94
– Start the engine and check that it is oil-tight.
Finishing work
– Check the engine oil level. ( p. 91)
– Install the engine guard. ( p. 64)
18.4 Adding engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
B01768-10
Main work
– Remove the oil filler plug
1
with the O-ring from the clutch cover.
– Fill engine oil to the middle
B
of the level viewer.
Engine oil (SAE 10W/50) ( p. 108)
Alternative 1
Engine oil (SAE 10W/60) ( p. 108)
Info
For optimal performance of the engine oil, do not mix different types of engine
oil.
If appropriate, change the engine oil.
– Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effec-
tive exhaust extraction system.
– Start the engine and check that it is oil-tight.
Finishing work
– Check the engine oil level. ( p. 91)
To Next Page
Loading...
Need help?
General
