HyPrecision 50S/60S/75S Operator Manual 808690 157
Troubleshooting
Section 7
Troubleshooting
Safety
Hypertherm products are designed and manufactured with a commitment to continuous quality control and
safety. Contact a Hypertherm Technical Service Associate for information and support regarding the installation,
operation, maintenance, and repair of this equipment.
Tips
Close all doors and replace all covers, including access covers.
Keep all interior parts and surfaces clean. Put all parts on a clean work surface.
Handle high-pressure parts with clean hands.
Before reassembling high-pressure or hydraulic parts, clean the parts to remove dirt and other contaminants.
Refer to the instruction manual. Read and understand all of the safety guidelines in this manual.
DANGER
Dangerous voltage
To reduce the risk of serious injuries or death, wear approved protection and follow safety
recommendations when working with electricity.
WARNING
Use a piece of cardboard or other solid material to find leaks when the pump is operating. Do not
use hands, cloth, paper, or towels.
WARNING
Do not touch a hot surface.
Fittings can get hot, especially when they are not tightened properly.
CAUTION
Failure to correct the cause of a leak can cause damage to the water fittings.
To Next Page
Loading...
Need help?
General
