SC-22 Safety and compliance
Symbols and marks
Symbols and marks
Symbols and marks found on the data plate and the equipment
Some symbols or marks in this table can apply to other products.
Prolonged exposure to noise can cause permanent hearing loss. Wear approved ear protection and
control exposure time when operating or working near this equipment.
High-pressure water can cause severe cuts or lacerations, abrasions, and punctures. Wear
approved hand protection when operating or working near this equipment.
Precision parts have sharp corners or edges. Wear protective gloves when handling parts.
Some materials produce airborne contaminants or suspended particles when cut. Wear approved
respiratory protection.
Refer to the instruction manual. Read and understand all of the safety guidelines in this manual.
This symbol identifies a mandatory action.
This symbol identifies a prohibited action.
This symbol identifies tools or materials that are required or recommended for a procedure.
This symbol identifies a note or helpful information.
Correct direction of motor rotation (motor rotation arrow)
S/N Serial number
V Volts
Φ Number of phases in a power system
Hz Frequency (hertz)
FLA Full-load current (amperage)
SCCR Short-circuit current rating
IP Ingress protection rating
Imax
Primary motor maximum current draw (amperes)
kW
Primary motor power output (kilowatts)
l/min Maximum outlet flow rate (liters/minute)
MPa Maximum outlet water pressure (megapascals)
DWG System schematic drawing number
To Next Page
Loading...
Need help?
General
