Hypertherm HyPrecision 50S User Manual

198 HyPrecision 50S/60S/75S Operator Manual 808690
9 – Installation
Installation
Turn on the utilities
1. Turn ON the electrical breaker.
2. Turn ON the water. Monitor for leaks. Identify the source of a leak and correct the problem. Refer to
Leaks on
page 163.
3. Make sure that the primary breaker disconnect lever on the electrical enclosure door is set to ON.
4. Turn ON the electrical power.
Change the system configuration on the operator interface
A password-protected system configuration menu permits the operator to change the language and to change
between psi and bar on the operator interface. Contact a Hypertherm Technical Service Associate for assistance.
WARNING
Do not attempt to repair a leak with pressure in the system.
WARNING
Use a piece of cardboard or other solid material to check for leaks when the pump is on. Do not
use hands, cloth, paper, or towels.

Hypertherm HyPrecision 50S Specifications

General

Brand	Hypertherm
Model	HyPrecision 50S
Category	Water Pump
Language	English