TV Card Software Control
Task Control Panel
– Use the Task Control Panel to switch the Factory-Installed TV card
between TV, Capture, and Teletex modes.
TV Tuner Panel
– Use the TV Tuner panel to control audio volume and muting.
Display Panel
– Use the mouse, the Control panel buttons, or the CTRL key to size
the Display panel. The display can be changed to these preset
sizes:
Table 5-2. TV card display size
160x120 pixels CTRL+1
240x180 pixels CTRL+2
320x240 pixels CTRL+3
640x480 pixels CTRL+5
Toggle between full screen
and current size
CTRL+F
CTRL+F
On-line Help
Context help is available in each panel by pressing the F1 key.
Bubble help is displayed when the mouse cursor is moved over a
control.
Troubleshooting
Select the symptom that best describes the problem and try the suggested
solutions. If the suggested solutions do not solve the problem, replace these
components one at a time:
Signal cable
Audio cable (if no sound)
TV card (if no sound or no picture)
Sound card (if no sound)
Riser card
System board
If other symptoms occur, Go to “Index of Symptoms, Messages, Error
Codes, or Beeps” on page 2-9.
Parts/Test Point Locations 5-17
To Next Page
Loading...
Need help?
General