Read BLK HDR
Displays the rst 80 characters of blocks header. By scrolling down, you can display the next 16
characters.
CE Block ID menu
Note: Use this only when directed by your next level of support.
Table 116 on page 144 shows the CE (Next) Block ID menu items. This menu allows the CE to show the
next block ID.
Table 116: Next Block ID menu
Function Next menu
Cancel “CE Process Tape menu” on page 142
Block ID :xxxxxxxx -
Cancel
Causes the “CE Process Tape menu” on page 142 to display.
Block ID
Displays the ID of the next block.
Enter Password menu
Note: Use this only when directed by your next level of support.
Table 117 on page 144
shows the Enter Password menu input areas.
This menu is displayed when you choose the Engr Use Only, Special Mode, or OEM Use Only menu.
Table 117:
Enter Password menu
Function Next menu
Cancel Previous menu
A… -
B… -
C… -
Done…
• “CE Engr Use Only menu” on page 145
• “CE Special Modes menu” on page 147
• “CE OEM Use Only menu” on page 147
Note:
1. Supplemental Message Line 1: Password:
2. Supplemental Message Line 2: <password>
Cancel
Causes the previous menu to display (see Figure 39 on page 91).
<character>
Provides and input area for the current password character that you must enter in each eld. Use the
Down Arrow to enter each eld and use Enter to advance through the available characters in each
eld. After the last letter is entered, press the Down Arrow, and select Done… The “CE Engr Use Only
menu” on page 145, the “CE Special Modes menu” on page 147, or the “CE OEM Use Only menu” on
144
IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information
To Next Page
Loading...
Need help?
General