Replacing the Rack Mount Card (RMC)
1. Install the RMC by using four screws.
2. Position the power supply bracket into the enclosure and turn the enclosure upside down.
3. Install four screws to secure the power supply bracket to the enclosure.
4. Turn the enclosure over.
5. Install both power supplies. See “FID 82: Power supply” on page 252.
6. Install both cables. See “FID EA: Cables FRU kit” on page 255.
7. Insert the enclosure into the rack. See “Removing the enclosure from a rack” on page 258.
8. Install the drives. See “FID 85: Drive canister” on page 252.
Removing the enclosure from a rack
1. Remove the two lter assembly screws and remove the assembly, if installed. See
7 and 8 in Figure
55 on page 170.
2. Remove the drives. See “Removing the drive canister from an enclosure” on page 253.
3. Disconnect the power cables from the power supplies. See “Removing drive canister power” on page
183.
4. Remove the two screws that secure the enclosure to the rack. See 4 in Figure 55 on page 170.
5. Remove the enclosure from the rack.
258 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information
To Next Page
Loading...
Need help?
General