IBM TS1160 User Manual

Setting WW names
Note:
1. If you alter any name, you must save or alter all the names. For example, if you alter the Node 0 Name
only, you must at least save Node 1, Port 0 and Port 1.
2. Refer to “Supplemental Messages” in Table 44 on page 79 for bre- addressing information.
1. Ensure that the drive is offline.
2. At the Options Display screen, press Change Mode . Select CE Offline Mode > Cong/Install >
Drv Options.
Note: The drive Serial No, Node 0 Name/Node 1 Name, Port 0 Name, and Port 1 Name must be
recorded. If not, see “Displaying WW names” on page 207, and enter the data in Table 145 on page
207, as necessary.
3. At the CE Drv Options menu, select Drv Serial No.
4. Select Alter Serial No. Increment each serial number digit, as necessary, to reflect the recorded
serial number.
Table 148: Alter Serial No - CE VPD Data menu
CE VPD Data J1A-F
►0 ▲
1
0
0
1
1
SAVE AND CONTINUE
SEQUENCE NUMBER
5. Select SAVE AND CONTINUE, then press Enter. This action causes the CE Save Data? menu to
display.
Table 149:
Alter Serial No - CE Save Data? menu
CE SAVE DATA? J1A-F
►CANCEL ▲
YES
NO
Supplemental Message section contents depend on
the data that is stored.
Serial
Sequence Number
Node 0/1
Noden FC WWID
Port 0/1
Portn FC WWID
6. Select YES, then press Enter to store the data into VPD memory and return you to the CE DRV Ser No
menu.
7. Select Cancel, as necessary to return to the CE Cong/Install menu.
8. Select Fibre Options, then select Set Node 0 Name.
9. Get the Node 0 Name from Table 145 on page 207 and enter the last 6 digits into VPD memory, as
shown in Table 150 on page 208. Increment the Node 0 Name digit positions to reflect the recorded
Node 0 name.
Table 150:
CE Set Node 0 Name menu
SET NODE 0 NAME J1A-F
208 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information

IBM TS1160 Specifications

General

Brand	IBM
Model	TS1160
Category	Storage
Language	English