associated drives, move them to another logical library or change them to unassigned
drives.
To create or remove a logical library, perform the following steps:
Procedure
1. From the Work Items navigation pane, select Library —> Logical Libraries. The
Manage Logical Libraries screen displays.
2. Perform one of the following:
• To add a logical library, follow the instructions on the screens to enter a
logical library name of up to 15 characters (duplicate names are not allowed).
Select the media type for the logical library.
• To remove a logical library, select it. From the drop-down box select Remove,
then select Go. The library displays the message Are you sure you want to
remove this logical library?
3. Select OK. The Success screen displays.
4. Select Close. The Manage Library screen redisplays with the new data.
Parent topic: Operating procedures
Changing the name of a logical library
Complete this task to change the name of a logical library in the TS3500 Tape Library.
About this task
Note: With the Advanced Library Management System (ALMS) is enabled, you can change
the name of a logical library in the TS3500 Tape Library by using the Tape Library Specialist
Web interface, but not by using the operator panel.
To change the name of a logical library, perform the following steps:
Procedure
1. From the Work Items navigation pane, select Library —> Logical Libraries. The
Manage Logical Libraries screen displays.
2. Select the name of the logical library that you want to change. From the dropdown
box select Rename, then select Go.
To Next Page
Loading...
Need help?
General