Tiny Modbus/TCP to RTU/ASCII Gateway
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved. - 61 -
5.3.4 Restore Factory Defaults
Use the following procedure to reset all parameters to their original factory default settings:
Step 1: Click the “Restore Defaults” button to reset the configuration.
Step 2: Click the “OK” button in the message dialog box.
Step 3: Check whether the module has been reset to the original factory default settings for use
with the eSearch Utility. Refer to
Chapter 3 “Getting Started for tGW-700/GW-2200 series using IPv4”
,
Chapter 4 “Getting Started for tGW-700/GW-2200 series using IPv6”
for more details.
The following is an overview of the factory default settings:
To Next Page
Loading...
Need help?
General
