Interlogix ATS3500A-IP-MM Installation And Programming Manual

Chapter 1: Quick installation and programming
4 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Quick programming
Initial start-up
Note: See “The Advisor Advanced menu”
on page 106 for menu explanation. For
more information on editing options, see
“How to program the options” on page 108.
Switch the panel on. The further messages
and menus are listed in the table below.
Display
Instructions
INFO
Inst required
Press Enter to continue.
1>Panel language
Choose English.
2>Defaults
Choose EN 50131 Grade 3.
4>PIN length
Enter 6.
5>Time&date
Set current time and date.
6 Install
>Cancel<
Choose OK
Installer
PIN:127800
Press Enter to continue.
Supervisor
PIN:112200
Press Enter to continue.
The panel restarts.
Auto configuration
Auto Config?
>Yes<
Press Enter to continue.
Rkp 1-16 BUS1
R-?-------------
Exp 1-15 BUS1
-?-------------
Wait until the panel
configures all bus devices
and zones.
Added
R:1 D:0 Z:8
Press Enter to continue.
Enabling service in
UTC F&S
THU 05 Mar 12:21
Press 112200, Menu
1>Zone options
2 Isolate
Go to menu 8.8 Service in
8>Service in
Enable?
Enable Installer in time
Press Cancel, Cancel to log off.
Programming menu entry
UTC F&S
THU 05 Mar 12:21
Press 127800, Menu
Inh reports
>No<
Press Enter to continue.
Inh tampers
Unset areas
1>Service menu
2 Device menu
The installer menu is displayed.
Changing installer PIN
Go to 3.1.n.2.1 Change PIN (see page 163).
1>Change PIN
***********
Press Enter.
New PIN
>_
Enter the new installer PIN.
Configuring zones
Go to 4.1 Zone menu (see page 171).
4>Zones&Areas
Press Enter.
1>Zone menu
Press Enter.
0>Add zone
1 Zone 1
Select a zone.
For each zone used in the system, enter
zone name in 4.1.n.1 Zone name (page
172).
01 Zone name
>1 Zone 1 <
Next, set its zone type in 4.1.n.2 Zone type
(see page 172).

Interlogix ATS3500A-IP-MM Specifications

General

Brand	Interlogix
Model	ATS3500A-IP-MM
Category	Security System
Language	English