Chapter 4: Programming
114 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Initial start-up
When switched on first time, the system prompts you to perform an installation.
Caution: It is only possible to perform the initial system installation from
keypad 1.
It is necessary to set appropriate default values for this particular system prior to
programming. The following settings can be defined during installation.
Table 23: Values set during installation
Defines the language* of the panel menus. This
language is used for messages when no user is
logged in. After login the language is switched to
the one assigned to the logged user (set by
system manager).
Defines approval* dependent default values.
Default duress method. See Advisor Advanced
Manager Manual for more information.
Default length of PIN (allowed range is from 4 to
10). See “8.7.4 PIN length” on page 250 for more
details.
Depends on the
firmware version
Time and date must be set during installation. See
also “8.1.1 Time and date” on page 232.
Run the installation process
* Contact your supplier for a list of available languages and approved versions.
Set the appropriate options and run the installation, then choose OK and press
Enter. The following messages are displayed:
1278 is the default PIN for master installer, and 1122 is the default PIN for a
supervisor.
Note: If the PIN length is configured for more than 4 digits, zeroes are added to
the default PIN values. For example, if the system is configured for 6-digit PINs,
the master installer PIN is 127800.
Confirm each screen with Enter.
To Next Page
Loading...
Need help?
General
