Chapter 3: System functions
92 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Wireless device programming
To add a wireless device, follow one of the following procedures.
Learning wireless sensors
There are two modes available for learning a wireless device, sequential and
manual.
Sequential mode
In sequential mode, you can quickly learn a range of wireless sensors.
To learn sensors in sequential mode:
1. Go to the “4.1.0 Add zone” menu described on page 171.
1>Expander 1
2 Expander 2
2. Select zone location.
3. Choose Sequential mode and press Enter.
4. Activate the wireless device. See “Device activation” on page 97 for more
information about activation.
If an error occurs, the keypad shows an error message and beeps seven times.
Example:
The error can occur, for example, when you try to learn a device, which is
already programmed in the wireless expander.
If the device is programmed successfully, the keypad beeps twice.
If there are more wireless devices to program, and the consecutive wireless
zones are available in the wireless expander, repeat activating another wireless
device.
To stop the learning process and exit the menu, press Clear.
To Next Page
Loading...
Need help?
General
