− 13 −
Loosen setscrew q and hold needle w with the long
groove facing toward you. Then fully insert it into the
hole in the needle bar, and tighten setscrew q.
If the stitches are made as shown in A,
attach the needle facing to the direction
B to a small extent.
[4] OPERATION OF THE SEWING MACHINE
1. Lubrication
2. Attaching the needle
w
e
A
B
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
q
Check that the place between lower line B and upper
line A is filled with oil. Fill there with oil using the oiler
supplied with the machine as accessories when oil is
short.
* The oil tank which is filled with oil is only for
lubricating to the hook portion. It is possible to
reduce the oil amount when the number of rotation
used is low and the oil amount in the hook portion
is excessive. (Refer to 8. Adjusting the amount of
oil in the hook of [7] MAINTENANCE.)
1. Do not lubricate to the places other
than the oil tank and the hook of
Caution 2 below. Trouble of
components will be caused.
2. When using the sewing machine for the
first time or after an extended period
of disuse, use the machine after
lubricating a small amount of oil to the
hook portion. (Refer to 2. Needle and
hook of [7] MAINTENANCE.)
A
B
To Next Page
Loading...
Need help?
General
